Shebolt (Anchor Head)
Shebolts consist of a Threadbar with a tightly pressed-on conical coupler. Shebolts are primarily used in combination with Loop or Hook Anchors that are embedded into the base plate. The conical anchor head is screwed onto both ends so that both anchors can be embedded without any protruding ends and is used for fixing single-sided shuttering or for similar applications. Following formwork stripping, the shebolt can be unscrewed from the base plate at the hex screw that is pressed on behind the cone. We recommend the atching PE Sleeves to facilitate unscrewing. After removal of the shebolt, the ends of the Loop or Hook Anchors do not have to be cut off with a circular saw. The ends are located approx. 5cm below the concrete edge. The conical hole simply has to be filled.
Article No. | Bar Ø [mm] | Ø1/Ø21) [mm] | Hex [mm] | Length2) [mm] | Weight [kg/no.] |
|---|---|---|---|---|---|
15 F 3045/28 | 15 | 28/32 | 24 | 200/750 | 1.75 |
20 F 3045 | 20 | 33/46 | 30 | 200/650 | 2.5 |
26 ES 3045 | 265 | 40/54 | 46 | 210/650 | 4.70 |
1) Ø1 = lower cone diameter;
Ø2 = upper cone diameter
2) Coupler length including pressed-on hex/total length Galvanized
Note: This article will be revised technically in all three dimensions.
Safety Instructions
Appropriate use of form ties and accessories is necessary to prevent accidents and failure. All products are intented to be used by qualified and experienced workmen. It is the user's responsibility to continually inspect working hardware for wear and to discard worn parts. Improper use of the DYWIDAG Form Ties can expose workers to extreme danger that may result in severe injury or death.
